Hero Member Offline Posts: The New Standard, 0. Plug in the four PCI-E cables to the miner.
Plug in an ethernet cable from the AntMiner to you router. Power on the power supply using its switch at the back. You can assume it is already on if you have a typical router. Using a browser, navigate to your router and find the IP it has assigned the S5 and navigate to that IP.
Login using "root" as both the username and password. Enter your pool information in the below format.
Navigate to the page "Miner Status" to check mining has started. Almost all "x" on one row of "Chips" - A hashing board may be mispowered or faulty. Try power cycling the miner and recheck your cabling and PSU. How do I change the login password? Enter the current password and the new one twice. What is the SSH login?
Can I turn the beeping off when the miner stops mining? Navigate to Miner configuration and turn "Beeper Ringing" to false. I can connect to the AntMiner but its not hashing?
What temperatures should I aim for? Without modification to the resistors you can safely stick with the frequency hex listed in table 1. Although it is purported that 2. To be able overclock take the Antminer U1 past 2. Antminer U1 Image above shows location of resistors and values of replacement resistors. Once the resistors are replaced you can change the frequency hex to options on table 2. Stay tuned for a whole lot more at coinreport. Click for image Click for featured image. Antminer it possible to overclock it in the UI of mulitminer or does it need to be done in bfgminer command? Notify me of follow-up comments by email.
Notify me of new posts by email. I did what you told me to do. I just got the S1 today and another one on its way. The S1 is staying at How do i fix this? You can always try to increase the frequency to MHz and see if the miner overclock run stable and with low number of HW errors, however most likely the number of errors will increase and though the local hashrate may be higher the actual one at the pool might be lower than running the device on the lower operating frequency.
Thanks for this website. The hardware rate is about 0. Of course I keep it in a 62 degree Fahrenheit room. I tried to overclock to How did you сколько майнит antminer s9 at the values you gave above?