Will the miner ever beep? I can connect to the Antminer but the status page is blank? What temperatures should I aim for? Where can I get the latest firmware?
How can I tell what firmware version I have now? How do I install the latest firmware? Solution - There is a faulty chip - nothing we can do. Try hard resetting the miner by powering it on and off. The miner will then reset with stock settings. Enter the current password and enter your new one twice. Post antminer screenshot of your configuration page if still unsure. Select the downloaded file and click "Flash image". First of all, please replace the power and 18 pin cable to try. Some chips antminer lost. X shown on the Hardware Version. Hash board cannot be detected.
There is no information shown on the Miner status interface. The miner works with normal hash rate when it was booted firstly.
After a while, there is no hash rate. A large number of antpools increased unreasonably. Hash rate is normal. There is no use resetting the router. There is a short circuit inside one of the hash board. It leads to automatic protection. The miner will get burnt powered by the PSU of poor quality. Test the miner with multimeter to find which part is defective.
Remove the defective part to repair. The PSU is defective. The hash boards are extensively defective resulting from the frequent network disconnection and continuous power supply. The miner tried to connect network frequently, which lead to program error litecoin antminer s5 hash board.
Catkins are likely to antminer internal miner cold road congestion. The control board cannot get power as the power antminer circuit in IO board is damaged. Hi, mi new S9 it doesnt works with the 3 has board, i can see one of them in the miner status. What can i do? Also switched a good hashboard to the bad miner, and was working Ok.
Should I send it to repair? If you have not already done so please email us at support bitmain. We can help you with your specific issue.
I get the hardware version x. Curious thing, I own 02 Antminers S7, and both came up with antminer same issue at the same time. Thank you for submitting a ticket. I have responded to the ticket antminer the information that you requested. Hi, i have an S9, and one of the boards showme a lots of "x", then i restart my miner, from the control panel, now the board doesnt turn on.
Antminer need to remove the damaged board to send it bitmain. I have my s7 cards have been damaging, sometimes when the frequency of to step back on sometimes not and in one of the cases the card comes on but the s7 does not have the same power does not reach 4.
All 17 of my miners stopped working at the same time and now say "socket connection failed, Good morning, I request your help since my S9 antminer presented a problem. The temperature of the third hashboard is no longer displayed and two groups of zeros have disappeared in the ASIC state. Upon powering up, the units will automatically begin hashingwhich can be useful in the event of power failure.
S7 connectivity is via Ethernet only. Both are cooled by dual fans. To help extend the life of these miners, it should be kept in a room with a cool and dry place. An ideal location for example is a dry basement. Все объявления - Текущая страница Аукцион Купить сейчас Тематические объявления. Сообщите нам свое местоположение.
Новые товары — это абсолютно новые, неиспользованные, нераспакованные и неповрежденные antminer. Монеты и банкноты Контракты antminer майнинг 8. Компьютеры, планшеты и периферия Дом и сад Antminer и промышленность