Antminer s1 cgminer

DinkoS1 May 2nd, at I brought one today for 0.

antminer s1 cgminer

Dave May 21st, at Sueche May 28th, at Antminer hile August 3rd, at Leave a Reply Cancel reply Your email address will not be published. If cgminer find helpful and useful information you can support us by donating altcoins or Bitcoin BTC to: OR It could be powered on for about 30 seconds then it shuts down.

How to Overclock Your Bitmain AntMiner S1 to GH/s - Crypto Mining Blog

Your problem antminer more cgminer likely in the PSU. Make sure you are not using the thin loose wire antminer paperclip for this If the Jumper Cable is jammed in and set correctly, it could be cgminer power supply unit. I understand that you could be using the W or even W PSU but it may not be strong enough to do the job.

Disconnect all the power cables from the 2nd Blade. Then Power On the AntMiner. Скорость гигахеш в секунду показать все Скорость гигахеш в секунду.

AntMiner S1 Tutorial

Гарантированная доставка показать все Гарантированная доставка. Не выбрано Применен фильтр. Состояние показать все Состояние. Формат показать все Формат. Все cgminer Применен фильтр Параметры доставки показать все Параметры доставки. Показывать только показать все Показывать. We clean up all thermal paste that we can get to, because when the device heats up under use, it will tend to antminer down the circuit bitmain antminer s4 asic if there is much of any left on the circuit board. So, clean what you can, and check the device after 10 minutes of run time antminer make sure more paste did cgminer sneak out from the screw holes.

Now, placement of the S1 is important. One into each blade. There should be a 6-pin cgminer female connector in the top center of each blade. Now, with cgminer power connected but not turned on yetplug in your Ethernet cable. I have not personally confirmed this myself, but there may be a reason to go via Ethernet cable.

Wait approximately 45 seconds after turning the power on before deeming everything as stable. We wait, antminer mining antminer not actually begin for approximately seconds after turning the device on. If all is well so far, it is time to connect to your AntMiner S1 and configure it.

antminer s1 | eBay

Cgminer into a computer on the same network as antminer AntMiner S1. Obtain the IP address of the S1 -- it should be on a sticker near the main fan. Most devices seem to have I will show you how to change the IP address shortly. Load up your Internet browser I recommend Chromeand navigate to http: You should be taken to a login screen.

antminer s1 cgminer

Click on "Miner Configuration" Next, configure your pools. Click "Save and Apply" when you are done configuring your pools.

Похожие статьи:

  • Как настроить antminer usb
  • Msi gtx 1060 aero itx 6g oc тест
  • Antminer s7 купить цена
  • Antminer s9 buy 1500 usd
  • Antminer s 2

  • Рекомендуем почитать:

  • подключить antminer s1
  • bitmaintech antminer что это
  • - 2018 (c)