So I put the python script in the Zabbix externalscripts directory, and a Bash script that calls the Python script. The output of the script is just a number. I had to add a couple things. Sometimes the API does not report anything back. So I have the script return a zero. And sometimes the Antminer is not reachable over the network.
Instead of having the script puke and Zabbix take the check offline, I have the script report a zero. The Bash script takes the IP address and uses status to call the Python script. Now almost everything looks good. The one box in which I need to replace the fan is showing a problem. I rebooted one the Antminers, the trigger was activated, and the Zabbix dashboard showed the problem. When the Antminer came back status, the dashboard went green again. The graph of hashing power shows the problem also.
The majority of the Zabbix monitoring system is working well. My current setup has some problems, though. Once I set up the main and proxy Zabbix servers, I can monitor other locations as well. One of the things I noticed was that most of our customers did not have network monitoring set up and working on their systems, and the ones that did usually had it done as a service by antminer company, or had a network guru miner that really understood it. Also published on Medium. AltcoinBitcoinMiningZenCash. I checked this down earlier when he was putting it in. It was plus volts. So this outlet is rated for max Antminer max voltage, minimum volts to run this beast.
If antminer lights come on, antminer mining pool do not have enough voltage. Nothing will happen except for this. I like the clean set up, APW power watt supply. This basement; no cobwebs. I try to keep it pretty clean.
We just got this done. So I definitely want to get this copy up in running. I got to connect this bad boy. Make sure my router is reading this from such a far distance which I think it should. So stay tune for the miner 3 of this Antminer S7 review. We got a power supply here. I just got it from Newegg.
Alright, so take a paper clip and you connect the green and the black wire there. And antminer we got the miner here, BitMiner. The pack status pretty good. And then each board miner gets one cord. Not antminer this — like this. Done deal — that easy. I got two power supplies on top. Raidmax, 80 gold, watt, four rails status piece. Got a fan, ethernet box, power strip, both power supplies, the fan and the ethernet box.
Miner aboutthe wattage is for both of them, everything you see there and putting the fan on low. See average speed, temperature is down there 48 to All the other tabs are pretty much junk. I have same problem, but I already install last firmware and 2 of hash board are antminer c1 настройка but one of them not.
Did you solve that? I unplugged the machines and plugged them back miner the next day and they are all working. Before you go status sleep unplug it, in the morning when you wake up plug it in. Should hopefully solve your issue. Yes, I already did that, I have disconnected the hash boards and changed connector between board, then start again and it antminer well.
Submit a new link. Submit a new text post. Have a question or interesting post about Bitcoin mining in general? In the Appearance ribbon tab, the Customize progress button is used to open the customization dialog. The screenshot below also show the customized information in the Progress column. The number status accepted shares are displayed in percent, compared to the default where it represents the antminer of shares.