Config antminer s1

The LAN is useless for users, but only useful to developers. If you forget, you will not be able to login into the miner.

config antminer s1

Just Go to Hashnest. Yes, if you use less wire, just to make sure you are not taxing all the energy into those wires. You can run it with 1 wire each, but distribute the energy to config tax each line is recommended. This is not the only way to set it up and you can tweak the setup as you please, but please do it safely! Are antminer currently being distributed only for evaluators, or are they out now and I missed it somehow? BTW, sushi, thanks for config info antminer s9 batch pics from your trip. Monitor all your miners config one place! This guide is generally excellent, kept it as reference on antminer side while setting my own machine up.

Antminer by SMF 1. February 04, So, clean what you can, and check the device after 10 minutes of run time to make sure more paste did not sneak out from the screw holes. Now, placement of the S1 is important. One into each blade. There should be a 6-pin input female connector in the top center of each blade.

config antminer s1

Now, with your power connected but not turned on yetplug in your Ethernet cable. I have not personally confirmed this myself, but there may be a reason to go via Ethernet cable. Wait approximately 45 seconds after turning the power on before deeming everything as stable.

[Setup & Troubleshoot] Bitmain AntMiner S1 GH/S miner

We wait, because mining does not actually begin for approximately seconds after turning the device on. If all is well so far, it is time to connect to your AntMiner S1 and configure it. Log into a computer on the same network as your AntMiner S1. Obtain the IP address of the S1 -- it should be on antminer sticker near the main fan. Most devices seem to have I antminer show you how to change the IP config shortly. Load up your Internet browser I recommend Chromeand navigate to http: You should be taken to a login screen. Click on "Miner Configuration" Next, configure your pools.

Click "Save and Apply" when you are done config your pools.

AntMiner S1 Wireless Tutorial

The mining software will automatically reset. You do not need to reboot the device. Click on the "Miner Status" tab. If it is fairly empty, wait seconds and click the Miner Status tab again. It should start to populate with lots of statistics. I will detail some of the important stats below. Check your client-side hash rate. Make sure both are connected to the 2nd blade If its power on, then the problem is for sure in your PSU. Please go get a brand name reliable PSU. Depends on your PSU Model, it may fix your looped auto-shutoff http: Please look at the above antminer. It will show you the pinout information. There are several different shapes of connectors and power specifications.

There are 2 kinds of config Connectors. An 8 antminer cgminer config volt cable has yellow wires on the same side as the connector clip.

Похожие статьи:

  • Antminer s5 что майнить
  • Antminer u3 usb btc шахтер
  • Asic bitcoin antminer
  • Msi gtx 1070 armor 8g прошивка биос

  • Рекомендуем почитать:

  • antminer t9 купить
  • настройка antminer s9 на nicehash
  • antminer s9 firmware download
  • - 2018 (c)